LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1391 (Frame & Underbody) >> Repair Instructions >> Damaged Cage Nut Service >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery ground (negative) cable.
    CAUTION: Refer to BATTERY DISCONNECT CAUTION .
    2. Fig 1: Removing Frame Bolt
    GM307714Courtesy of GENERAL MOTORS CORP.
  2. Remove the frame bolt (2) from the frame crossmember nut.
    3. Fig 2: Removing Frame Crossmember Nut
    GM307715Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The frame crossmember nut retainer will be reused if not damaged from the stripped out bolt.
  3. Break away the spot welds (1) on one side of the frame crossmember nut retainer with an air chisel.
  4. Lift one side of the frame crossmember nut retainer (enough to remove the frame crossmember nut).
  5. Remove the frame crossmember nut.
scientia non olet · About LEMON Manuals