Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Assist Step Front Cover & Push-In Retainer

Courtesy of GENERAL MOTORS CORP.

Remove the push-in retainer from the assist step front cover.
Remove the cover from the vehicle.

Fig 2: Removing Assist Step Rear Cover & Push-In Retainer

Courtesy of GENERAL MOTORS CORP.

Remove the push-in retainer from the assist step rear cover.
Remover the cover from the vehicle.

Fig 3: Removing Bottom Fender Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the bottom fender bolt (2) from the vehicle.

Fig 4: Removing Assist Step Brackets & Bolts

Courtesy of GENERAL MOTORS CORP.

With an assistant, remover the bolts (3,1) from the assist step brackets.
Remove the assist step from the vehicle.
Remove the heater and A/C tubes retaining nuts from the studs, if equipped. Refer to HEATER PIPE .
Remove the assist step bolts (6) from the brackets.
Remove the brackets from the vehicle.