LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1390 (Engine Exhaust System) >> Repair Instructions >> Exhaust Heat Shield Replacement - Dash Panel >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left Exhaust Heat Shield & Nuts
    GM707396Courtesy of GENERAL MOTORS CORP.
  1. If installing the heat shield (3), install the shield through the passenger side wheelwell.
  2. Install the exhaust heat shield (1, 3) to the dash panel studs.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the exhaust heat shield nuts.

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  4. Lower the vehicle.