LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Engine Controls - Removal, Overhaul & Installation - 6.6L Diesel) >> Fuel Systems >> Fuel Tank >> Removal & Installation (Cab & Chassis Primary)

Removal & Installation (Cab & Chassis Primary)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the fuel tank. Raise the vehicle. Remove the fuel tank shield. Disconnect the fuel fill and vent pipes from the fuel tank. Support the fuel tank, with the aid of an assistant.
  2. Remove the fuel tank strap attaching bolts. Remove the fuel tank straps. Lower the fuel tank slightly. Disconnect the fuel pipes from the fuel sender. See QUICK CONNECT FITTINGS (METAL COLLAR) . If equipped with an auxiliary fuel tank disconnect the rear chassis balance pipes.
  3. Disconnect the fuel sender harness connector. Remove the fuel tank. Place the fuel tank in a suitable work area. Cap the fuel pipes on the vehicle in order to prevent possible fuel system contamination. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals