Removal & Installation
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Turn OFF the ignition. Disconnect the BARO sensor electrical connector. See Fig 1. Bend the locking tab, located on the bracket, away from the sensor, just enough so that the sensor will pass. Pull the BARO sensor downward to remove it from the bracket. To install, reverse removal procedure.