LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1389 (Body Front End) >> Repair Instructions >> Air Inlet Grille Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the windshield washer hose to the nozzle under the center air inlet grille panel.
    2. Fig 1: Air Inlet Grill Panel & Clips
    GM348546Courtesy of GENERAL MOTORS CORP.
  2. Position the air inlet grille panel to the vehicle and attach the clips to the edges of the center air inlet grille panel.
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the sheet metal screws on each end of the air inlet grille panel.

    Tighten:  Tighten the sheet metal screws to 2 N.m (18 lb in).

    4. Fig 2: View Of Cowl Vent Grille Panel Outboard Section
    GM334315Courtesy of GENERAL MOTORS CORP.
  4. Align the outboard air inlet grille panel clips and press down in order to install.
  5. Install the wiper arms. Refer to WIPER ARM REPLACEMENT .
scientia non olet · About LEMON Manuals