Test Description
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers in the diagnostic table.
- 1: The Diagnostic System Check-Engine Controls prompts the technician to complete some basic checks and store the Freeze Frame data on the scan tool if applicable. This creates an electronic copy of the data taken when the fault occurred. The information is then stored in the scan tool for later reference.
- 2: This step determines if the fault is present.
DTC P0016
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you perform the Diagnostic System Check-Engine Controls? | Go to Step 2 | Go to Diagnostic System Check - Engine Controls |
| 2 |
|
Go to Step 3 | Go to Intermittent Conditions |
| 3 |
|
Go to Step 5 | Go to Step 4 |
| 4 | Replace the PCM. Refer to Powertrain Control Module (PCM) Replacement
. Did you complete the replacement? |
Go to Step 5 | - |
| 5 |
|
Go to Step 6 | Go to Step 2 |
| 6 | With a scan tool, observe the stored information, Capture Info. Does the scan tool display any DTCs that you have not diagnosed? |
Go to Diagnostic Trouble Code (DTC) List | System OK |