LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1380 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Receiver Dehydrator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Discharge and recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
    2. Fig 1: Pressure Switch, Receiver, Bolts, Screws And Inlet Tube
    GM834073Courtesy of GENERAL MOTORS CORP.
  2. Remove the pressure switch (3) from the receiver (6). Refer to Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement .
  3. Remove the bolt (4) and liquid tube from the receiver.
  4. Remove the bolt (5) and tube from the condenser.
  5. Remove the 2 screws (7) from the receiver.
  6. Remove the receiver from the vehicle.
scientia non olet · About LEMON Manuals