LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1380 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Condenser Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cooling fan assembly. Refer to Cooling Fan Replacement - Electric in Engine Cooling.
  2. Discharge and recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
    3. IMPORTANT: Cap the open fittings in order to prevent dirt and moisture from entering the refrigeration system.
  3. Remove the receiver from the condenser. Refer to Receiver Dehydrator Replacement .
    4. Fig 1: Pressure Switch, Receiver, Bolts, Screws And Inlet Tube
    GM834073Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolt and the condenser inlet tube (1).
    5. Fig 2: Support Bracket And Condenser Bolts
    GM834083Courtesy of GENERAL MOTORS CORP.
  5. Remove the 2 bolts (2) from the radiator support bracket.
  6. Remove the brackets from the vehicle.
  7. Remove the two bolts (1) from condenser.
    8. Fig 3: Radiator
    GM834084Courtesy of GENERAL MOTORS CORP.
  8. Lean the radiator back and Remove the condenser.
scientia non olet · About LEMON Manuals