LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1380 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Clutch Rotor and/or Bearing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Clutch Rotor And Bearing Assembly, Pulley And Bearing Installer And Bearing
    GM157226Courtesy of GENERAL MOTORS CORP.
  1. Position the clutch rotor and bearing assembly (2) onto the compressor.
  2. Position the J 33017  and bearing (1) from the J 33013-B  directly over the inner race of the bearing. See Special Tools and Equipment .
  3. Place the washer (3) onto the body of J 33013-B  . See Special Tools and Equipment .
  4. Remove the center screw from the body of the hub and drive plate installer.
  5. Install the center screw into the opposite end of the hub and drive plate installer.
  6. Back the body of the hub and drive plate installer tool off enough to allow the center screw to be threaded onto the end of the compressor shaft.
  7. Thread the center screw several turns onto the end of the compressor shaft.

    Do not tighten the center screw on the compressor shaft.

  8. Hold the center screw with a wrench.
  9. Tighten the hex portion of the hub and drive plate installer body several turns.
    10. Fig 2: Removing/Installing A/C Rotor/Hub Snap Ring
    GM157223Courtesy of GENERAL MOTORS CORP.
  10. Remove the J 33013-B  from the clutch rotor and bearing assembly. See Special Tools and Equipment .
  11. Ensure that the clutch rotor and bearing (2) is pressed onto the nose of the compressor far enough to clear the groove for the retaining ring.

    If the clutch rotor and bearing does not clear the groove, repeat steps 7, 8 and 9.

  12. Install the clutch rotor and bearing retaining ring (3) using external snap ring pliers (1).

    Ensure that the chamfer side of the retaining ring is facing up when the retaining ring is being installed.

  13. Install the clutch plate and hub assembly.
  14. Remove the compressor from the J 41790-A  . See Special Tools and Equipment .
  15. Install the A/C compressor. Refer to Compressor Replacement .
scientia non olet · About LEMON Manuals