LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1380 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Resistor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Blower Motor Resistor Electrical Connector, Blower Case, Motor And Screws
    GM325437Courtesy of GENERAL MOTORS CORP.
  1. Install the blower motor resistor (4) to the blower case. Secure with the 2 screws.
  2. Connect the blower motor resistor electrical connector.
  3. Install the IP compartment. Refer to Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals