LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1380 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: PCM Close Out Panel
    GM856534Courtesy of GENERAL MOTORS CORP.
  1. Remove the two retainers from the PCM close out panel (1) below the instrument panel (IP) compartment door.
  2. Swing the PCM close out panel (1) down.
    3. Fig 2: IP Compartment And Tabs
    GM834062Courtesy of GENERAL MOTORS CORP.
  3. Open the IP compartment.
  4. Push in on both sides of the IP compartment in order to release the safety catches.
  5. Remove the IP compartment door assembly from the IP.
    6. Fig 3: PCM Bracket Fasteners
    GM834064Courtesy of GENERAL MOTORS CORP.
  6. Remove the two PCM bracket fasteners.
    7. Fig 4: PCM, Brackets And Blower Motor Electrical Connector
    GM856535Courtesy of GENERAL MOTORS CORP.
  7. Pull the PCM (2) with brackets (3) toward you and swing both down away from under the IP.
  8. Disconnect the blower motor electrical connector.
  9. Remove the blower motor cooling tube.
    10. Fig 5: Blower Motor, Fan And Bolts
    GM835120Courtesy of GENERAL MOTORS CORP.
  10. Remove the three bolts (2) and the blower motor and fan (1) from the vehicle.
scientia non olet · About LEMON Manuals