LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1380 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Blower Motor, Fan And Bolts
    GM835120Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the blower motor and fan (1) to the vehicle. Secure with the three bolts (2).

    Tighten:  Tighten the bolts (2) to 10 N.m (89 lb in)

  2. Install the blower motor cooling tube.
  3. Connect the blower motor electrical connector.
  4. Swing the PCM (2) with bracket (3) up in position under the IP.
    5. Fig 2: PCM Bracket Fasteners
    GM834064Courtesy of GENERAL MOTORS CORP.
  5. Secure the PCM to the IP with the two fasteners.

    Tighten:  Tighten the two fasteners to 9 N.m (80 lb in).

    6. Fig 3: IP Compartment And Tabs
    GM834062Courtesy of GENERAL MOTORS CORP.
  6. Install the IP compartment door into the IP.
    7. Fig 4: PCM Close Out Panel
    GM856534Courtesy of GENERAL MOTORS CORP.
  7. Swing the close out panel (1) up under the PCM.

    Secure the close out panel (1) to the PCM with the two retainers.

scientia non olet · About LEMON Manuals