LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1380 (Heating, Ventilation And Air Conditioning) >> Diagnostic Information and Procedures >> Noise Diagnosis - Blower Motor

Noise Diagnosis - Blower Motor

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Noise Diagnosis - Blower Motor

Step Action Yes No
DEFINITION: Noise originating from the blower motor.
1 Were you sent here from Symptoms - HVAC Systems - Manual? Go to Step 2  Go to Symptoms - HVAC Systems - Manual in HVAC Systems Manual.
2
  1. Sit inside the vehicle.
  2. Close the vehicle doors and windows.
  3. Turn ON the ignition, with the engine OFF.
  4. Cycle the blower motor through all of the speeds and modes in order to determine where and when the noise occurs.
Is a noise evident during the blower operation?
Go to Step 3  Go to Step 10 
3 Does the noise vary with the blower speed? Go to Step 4  Go to Step 10 
4 Inspect for excessive vibration at each blower motor speed by feeling the blower case.
Is excess vibration present?
Go to Step 5  Go to Step 10 
5 Remove the blower motor. Refer to Blower Motor Replacement .
Inspect the blower motor for deposits of foreign material.
Did you find any foreign material on the blower motor?
Go to Step 7  Go to Step 6 
6 Inspect the blower motor for the following conditions:
  • Cracked blades
  • A loose impeller retainer
  • Improper impeller alignment

Did you find any of these conditions?
Go to Step 8  Go to Step 9 
7 Remove the foreign material.
Is the action complete?
Go to Step 10  -
8 Replace the blower motor. Refer to Blower Motor Replacement .
Is the replacement complete?
Go to Step 10  -
9 Install the blower motor. Refer to Blower Motor Replacement .
Is the action complete?
Go to Step 10  -
10 Operate the system in order to verify the repair.
Does the system operate correctly?
System OK Go to Step 2