LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1379 (Manual Transmission Clutch System) >> Repair Instructions >> Release Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the manual transaxle from the vehicle. Refer to Transaxle Replacement in Manual Transmission -MK5 or Transaxle Replacement in Manual Transmission - MTN.
    2. Fig 1: Removing Clutch Release Bearings And Release Fork
    GM235978Courtesy of GENERAL MOTORS CORP.
  2. Remove the clutch release bearing and the clutch release fork at the same time.
  3. Remove the clutch release bearing from the clutch release fork.
  4. Clean the clutch release bearing using a clean dry solvent free cloth.
  5. Inspect the clutch release bearing for external damage and smooth rotation. Replace the clutch release bearing for the following conditions:
    • External damage
    • The bearings do not operate smoothly.
scientia non olet · About LEMON Manuals