Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Clutch Release Bearings And Release Fork

Courtesy of GENERAL MOTORS CORP.

Lubricate the clutch release bearing using a thin coat of wheel bearing grease of GM P/N 1051344 (Canadian P/N 9930337) or the equivalent.
Install the clutch release bearing to the clutch release fork.
Install the clutch release bearing and the clutch release fork assembly onto the transaxle assembly.
Install the manual transaxle from the vehicle. Refer to Transaxle Replacement in Manual Transmission -MK5 or Transaxle Replacement in Manual Transmission - MTN.