LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1379 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Pedal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Remove the Lower Instrument Panel. Refer to Instrument Panel (I/P) Trim Panel Replacement - Lower .
    3. Fig 1: Removing/Installing Clevis Clip And Pin
    GM885330Courtesy of GENERAL MOTORS CORP.
  3. Remove the clevis clip and the pin.
  4. Disconnect the Clutch Pedal Position (CPP) switch electrical connector.
  5. Disconnect the Cruise Control Release (CCR) switch electrical connector.
    6. Fig 2: Pedal Assembly Bracket Retaining Nuts And Retaining Bolt
    GM885331Courtesy of GENERAL MOTORS CORP.
  6. Remove the 2 pedal assembly bracket retaining nuts and the 1 retaining bolt.
  7. Remove the clutch pedal assembly from the vehicle.
scientia non olet · About LEMON Manuals