LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1379 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Pedal Position Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the CPP switch lock nut to the CPP switch.
  2. Install the CPP switch into the clutch and the brake pedal bracket by turning the CPP switch clockwise.
  3. Use the J 39200  in order to adjust the clutch pedal position CPP switch.
    4. Fig 1: Clutch Pedal Depressed To Floor
    GM184799Courtesy of GENERAL MOTORS CORP.
  4. Depress the clutch pedal (2) to the floor (3). Return the clutch pedal within 15-30 mm (0.6-1.2 in) from the floor.
    5. Fig 2: Adjusting Probes Of CPP Switch Electrical Connector
    GM184795Courtesy of GENERAL MOTORS CORP.
  5. Adjust the probes of J 39200  in contact with both leads of the CPP switch electrical connector (2).
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Adjust the CPP switch by threading the switch into the clutch and the brake pedal bracket until the continuity is achieved.

    Tighten:  Tighten the CPP switch lock nut to 13 N.m (115 lb in).

  7. Connect the electrical connector to the CPP switch.
  8. Connect the negative battery cable.
scientia non olet · About LEMON Manuals