LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1379 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Pedal Engine Start Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the clutch start switch and retaining nut.

    Tighten:  Tighten the retaining nut to 16 N.m (12 lb ft).

  2. Connect the clutch start switch electrical connector.
  3. Check the clutch start switch for proper operation.
scientia non olet · About LEMON Manuals