LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1379 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the clutch disc to the flywheel with the torsion springs offset toward the transaxle. Using a suitable clutch alignment arbor to center and hold in place the clutch disc on the flywheel.
  2. Install the clutch pressure plate to the flywheel. Secure the flywheel with the 6 clutch pressure plate cover bolts.

    Tighten:  Tighten the clutch pressure plate cover bolts to 19 N.m (14 lb ft).

  3. Remove the clutch alignment arbor.
  4. Lubricate the transaxle input shaft splines and clutch release bearing using a thin coat of wheel bearing grease GM P/N 1051344 (Canadian P/N 993037) or the equivalent.
  5. Install the manual transaxle assembly into the vehicle. Refer to Transaxle Replacement in Manual Transmission -MK5 or Transaxle Replacement in Manual Transaxle - MTN.
scientia non olet · About LEMON Manuals