LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1373 (Propeller Shaft) >> Repair Instructions >> Propeller Shaft Replacement - Two Piece >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Sliding Yoke
    GM635267Courtesy of GENERAL MOTORS CORP.
  1. Install the sliding yoke (1) into the transmission with the two piece propeller shaft assembly.
  2. Ensure that the sliding yoke splines are lubricated.
    3. Fig 2: Shaft Bearing Support Bolts
    GM814956Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the mid shaft bearing support bolts (1,2).

    Tighten:  Tighten the bolts to 37 N.m (27 lb ft).

  4. Install the pinion flange yoke to the differential pinion flange with the reference marks. Secure the pinion flange yoke with 4 bolts and 4 nuts and washers.

    Tighten:  Tighten the propeller shaft bolts and nuts to 74 N.m (54 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals