Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Place alignment marks on the cross groove joint and universal joint flange.
- Remove the cross joint retaining bolts.
- Support the propeller shaft assembly.
- Remove the propeller shaft. Refer to Propeller Shaft Replacement - Two Piece in this section.
- Using a hammer and chisel, unstick the universal joint flange retaining nut.
- Using a vise to hold the front flange, remove the nut and plate washer.
- Place alignment marks on the universal joint flange (1).
- Using a two jaw puller, remove the universal joint flange.
- Remove the center support bearing and plate washer from the propeller shaft.
- Turn the bearing by hand, check the bearing for smooth rotation.
- Inspect the center bearing for wear or damage.
- Inspect the seals for cracks or distortion.
IMPORTANT:
Place a shop rag or equivalent into the inside of the cross groove joint cover so the boot does not touch the inside of the cross groove joint cover after the bolts have been removed.