Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: Heated Oxygen Sensor (HO2S1), Exhaust Pipe Hanger, Springs And Bolts

Courtesy of GENERAL MOTORS CORP.

Install the muffler/tail pipe assembly, with a new gasket, to the vehicle.
Install the hangers to the muffler.
Install the bolt and clamp to the three-way catalytic converter (TWC) assembly:
Tighten: Tighten the clamp bolt to 32 N.m (24 lb ft).
Lower the vehicle.