Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: (HO2S1) And (HO2S2) Electrical Connector, Exhaust Pipe Hangers, Springs And Bolts

Courtesy of GENERAL MOTORS CORP.

Install the muffler/tail pipe assembly, with a new gasket, to the vehicle.
Install the hangers to the muffler.
Install the springs and bolts to the three-way catalytic converter (TWC) (3) assembly:
Tighten: Tighten the clamp bolt to 43 N.m (32 lb ft).
Lower the vehicle.