Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 43631 Ball Joint Remover

If the vehicle has rear disc brakes, remove the rear brake rotor. Refer to Brake Rotor Replacement - Rear in Disc Brakes.
If the vehicle has rear drum brakes, remove the brake drum. Refer to Brake Drum Replacement in Drum Brakes.
Install 2 wheel nuts onto 2 studs.
Use a pry bar on the 2 nuts in order to prevent the hub from turning.

Fig 1: Removing Wheel Stud From Axle Flange

Courtesy of GENERAL MOTORS CORP.

Use the J 43631 in order to remove the wheel stud.