LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1370 (Rear Suspension System) >> Repair Instructions >> Upper Control Arm Replacement (AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear drive module. Refer to Crossmember Replacement (AWD) .
    2. Fig 1: Upper Control Arm, Nuts And Bolts
    GM829427Courtesy of GENERAL MOTORS CORP.
  2. Use paint in order to place match marks on the camber adjust cams and on the upper control arm (1).
  3. Remove the nut (2) and the bolt (3) in order to separate the upper control arm from the knuckle.
  4. Remove the nut from the cam bolt.
  5. Remove the rear cam from the cam bolt.
  6. Remove the cam bolt and the upper control arm from the crossmember.
scientia non olet · About LEMON Manuals