Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Stabilizer Shaft, Nuts And Bolts (FWD)

Courtesy of GENERAL MOTORS CORP.

Use the mark on the left rear side of the stabilizer shaft (5) in order to position the shaft on the rear axle (1).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 bolts (3,4) and the 2 nuts (2,6) in order to retain the shaft to the axle.
Tighten: Tighten the nuts and the bolts to 195 N.m (143.8 lb ft).