Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Stabilizer Shaft, Link And Nuts

Courtesy of GENERAL MOTORS CORP.

Install the link (1) to the stabilizer shaft (3).
Install the link to the knuckle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 nuts (2,4) to the link studs.
Tighten: Tighten the nuts to 44 N.m (32.5 lb ft).