Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Shaft Insulators, Stabilizer Shaft, Brackets, Nuts And Bolts (AWD)

Courtesy of GENERAL MOTORS CORP.

If you are replacing the insulators (6,13), copy the match marks from the old components to the new components.
Align the match marks and install the insulators to the shaft.
Install the brackets to the insulators.
Install the 4 bolts (3,4,8,9) to the brackets.
Tighten: Tighten the bolts to 18 N.m (13.3 lb ft).
Install the rear drive module. Refer to Crossmember Replacement (AWD) .