LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1369 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (FWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the stabilizer shaft on the crossmember.
  2. Install the 2 stabilizer shaft insulators to the stabilizer shaft.
  3. Install the 2 clamps to the insulators.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the 4 bolts to the clamps.

    Tighten:  Tighten the bolts to 19 N.m (14.0 lb ft).

    5. Fig 1: Stabilizer Shaft Link Bolts (FWD)
    GM828029Courtesy of GENERAL MOTORS CORP.
  5. Install the 2 stabilizer shaft links and the 2 nuts (2) to the stabilizer shaft.

    Tighten:  Tighten the nuts to 74 N.m (54.6 lb ft).

  6. Install the stabilizer shaft and the crossmember to the vehicle. Refer to Crossmember Replacement - Front Suspension (FWD)  or Crossmember Replacement - Front Suspension (AWD) .
scientia non olet · About LEMON Manuals