LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1369 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front suspension crossmember. Refer to Crossmember Replacement - Front Suspension (FWD)  or Crossmember Replacement - Front Suspension (AWD) .
    2. Fig 1: Strut Bracket, Stabilizer Shaft Links And 6 mm Wrench (AWD)
    GM821347Courtesy of GENERAL MOTORS CORP.
  2. Remove the 2 nuts and the 2 stabilizer shaft links (3) from the stabilizer shaft.
  3. Remove the 4 bolts and the 2 stabilizer shaft clamps.
  4. Remove the 2 stabilizer shaft insulators.
  5. Remove the stabilizer shaft.
scientia non olet · About LEMON Manuals