Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Use a 6 mm wrench in order to hold the stabilizer shaft link upper stud. Install the nut and the stud to the bracket (1) on the strut.
Tighten: Tighten the nut to 74 N.m (54.6 lb ft).
- Use a 6 mm wrench in order to hold the stabilizer shaft link lower stud. Install the nut and the stud to the stabilizer shaft.
Tighten: Tighten the nut to 74 N.m (54.6 lb ft).
- Install the front tire and wheel assembly to the vehicle. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle.