LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1369 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (FWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the following components as an assembly. Refer to Crossmember Replacement - Front Suspension (FWD)  or Crossmember Replacement - Front Suspension (AWD) .
    • The front suspension crossmember
    • The trans support
    • The front control arms
    • The stabilizer shaft
    • The stabilizer shaft links
    • The stabilizer shaft clamps
    • The stabilizer shaft insulators
    2. Fig 1: Stabilizer Shaft Clamps, Bolts And Shaft Insulators (FWD)
    GM1464391Courtesy of GENERAL MOTORS CORP.
  2. Remove the 4 bolts from the stabilizer shaft clamps.
  3. Remove the 2 stabilizer shaft clamps.
  4. Remove the 2 stabilizer shaft insulators.
scientia non olet · About LEMON Manuals