Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Stabilizer Shaft Clamps, Bolts And Shaft Insulators (AWD)

Courtesy of GENERAL MOTORS CORP.

Install the 2 stabilizer shaft insulators to the stabilizer shaft.
Install the 2 clamps and the 4 bolts to the insulators.
Install the crossmember to the vehicle. Refer to Crossmember Replacement - Front Suspension (FWD) or Crossmember Replacement - Front Suspension (AWD) .

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 4 bolts to the clamps.
Tighten: Tighten the bolts to 19 N.m (14.0 lb ft).