LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1369 (Front Suspension System) >> Repair Instructions >> Lower Ball Joint Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Remove the weight of the vehicle from the tires and the lower control arms.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Use a jack in order to support the front suspension crossmember.
    3. Fig 1: Control Arm Nuts And Bolts
    GM821222Courtesy of GENERAL MOTORS CORP.
  3. Remove the 2 nuts (1,2) and the bolt (3).
  4. Remove the lower control arm from the ball joint.
  5. Remove the cotter pin from the ball joint stud.
  6. Remove the nut from the ball joint stud.
  7. Use the appropriate ball joint remover in order to remove the ball joint from the knuckle.
scientia non olet · About LEMON Manuals