LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1368 (Power Steering System) >> Repair Instructions >> Power Steering Reservoir Outlet Pipe/Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Power Steering Reservoir, Hose And Clamps
    GM850338Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Installing Hoses without Twists or Bends Notice in Cautions and Notices.
  1. Install the reservoir outlet hose (3) to the power steering fluid reservoir.
  2. Install the hose clamp (2) in order to retain the hose to the reservoir.
  3. Install the reservoir outlet hose to the power steering pump.
  4. Install the hose clamp (4) in order to retain the hose to the pump.
    5. NOTE: Refer to Using Proper Power Steering Fluid Notice in Cautions and Notices.
  5. Fill the power steering fluid reservoir. Refer to Checking and Adding Power Steering Fluid .
    6. NOTE: Refer to Air in the Power Steering System Notice in Cautions and Notices.
  6. Bleed the power steering system. Refer to Bleeding the Power Steering System .
scientia non olet · About LEMON Manuals