LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1368 (Power Steering System) >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement (AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place a drain pan under the vehicle in order to catch any power steering fluid.
    2. Fig 1: Power Steering Gear Inlet Pipe/Hose Components (AWD)
    GM850395Courtesy of GENERAL MOTORS CORP.
  2. Remove the bolt (5) from the power steering gear inlet hose (4).
    3. NOTE: Refer to Power Steering Hose Disconnected Notice in Cautions and Notices.
  3. Remove the pipe fitting (6) and the gear inlet hose from the steering gear (7).
  4. Remove the bolt (3).
  5. Remove the pipe fitting (2) and the gear inlet hose from the pump.
scientia non olet · About LEMON Manuals