LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1368 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement (AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place a drain pan under the vehicle in order to catch any power steering fluid.
    2. Fig 1: Fluid Cooler Pipe, Bolts And Hose Clamps (AWD)
    GM850382Courtesy of GENERAL MOTORS CORP.
  2. Remove the bolt (7) from the power steering fluid cooler pipe (6).
  3. Remove the bolt (3) from the cooler pipe.
  4. Remove the bolt (5) from the cooler pipe.
  5. Loosen the clamp (4) that retains the power steering cooler pipe to the end of the power steering gear outlet hose.
    6. NOTE: Refer to Power Steering Hose Disconnected Notice in Cautions and Notices.
  6. Remove the gear outlet hose from the cooler pipe.
  7. Loosen the clamp (1) that retains the cooler pipe to the power steering fluid reservoir.
  8. Remove the cooler pipe from the reservoir.
scientia non olet · About LEMON Manuals