LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1368 (Power Steering System) >> Diagnostic Information and Procedures >> Whine or Growl Noise from the Power Steering System

Whine or Growl Noise from the Power Steering System

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Whine or Growl Noise from the Power Steering System

Step Action Yes No
1 Did you review the Power Steering System Description and Operation and perform the necessary inspections? Go to Step 2  Go to Symptoms - Power Steering System 
2 Verify that a whine or growl noise is present.
Is a whine or growl noise present?
Go to Step 3  System OK
3 Perform the power steering test procedure in order to diagnose a hydraulic condition and repair or replace a component. Refer to Power Steering System Test Procedure .
Did you repair or replace a power steering system component?
Go to Step 10  Go to Step 4 
4 Use the J 39570  Chassis Ear in order to inspect the power steering gear for a whine or a growl noise.
Is the noise present at the power steering gear?
Go to Step 7  Go to Step 5 
5 Use the J 39570  in order to inspect the power steering pump for a whine or a growl noise.
Is the noise present at the power steering pump?
Go to Step 8  Go to Step 6 
6 Use the J 39570  in order to inspect the power steering pipes and hoses for a whine or a growl noise.
Is the noise present at the power steering pipes and hoses?
Go to Step 9  Go to Step 2 
7 Replace the power steering gear. Refer to Power Steering Gear Replacement (FWD)  or Power Steering Gear Replacement (AWD) .
Did you complete the repair?
Go to Step 10  -
8 Replace the power steering pump. Refer to Power Steering Pump Replacement .
Did you complete the repair?
Go to Step 10  -
9 Adjust the routing of the power steering pipes and hoses.
Did you complete the repair?
Go to Step 10  -
10 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3