LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1366 (Drum Brake System) >> Repair Instructions >> Drum Brake Backing Plate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel cylinder. Refer to Wheel Cylinder Replacement .
  2. Remove the bolt and the park brake cable from the backing plate.
  3. Remove the rear wheel bearing and hub assembly. Refer to Wheel Bearing/Hub Replacement - Rear (FWD) or Wheel Bearing/Hub Replacement - Rear (AWD) in Rear Suspension.
    4. Fig 1: Exploded View Of Drum Brake System
    GM819274Courtesy of GENERAL MOTORS CORP.
  4. Remove the backing plate (5).
scientia non olet · About LEMON Manuals