LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1366 (Drum Brake System) >> Repair Instructions >> Drum Brake Backing Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Drum Brake System
    GM819274Courtesy of GENERAL MOTORS CORP.
  1. Install the backing plate (5) with the rear wheel bearing and hub assembly. Refer to Wheel Bearing/Hub Replacement - Rear (FWD) or Wheel Bearing/Hub Replacement - Rear (AWD) in Rear Suspension.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the park brake cable and the bolt to the backing plate.

    Tighten:  Tighten the bolt to 7.8 N.m (69.04 lb in).

  3. Install the wheel cylinder. Refer to Wheel Cylinder Replacement .
scientia non olet · About LEMON Manuals