Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Proportioning Valve Components

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the proportioning valve (7) and the 2 bolts (5,6) to the cowl.
Tighten: Tighten the bolts to 5.4 N.m (47.79 lb in)
Install the brake pipes to the proportioning valve.
Tighten the flare nuts (1,2,3,4,8)
Tighten: Tighten the flare nuts to 15.2 N.m (11.2 lb ft).
Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding .