Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.

Fig 1: Brake Hose Components (Drum Brakes)

Courtesy of GENERAL MOTORS CORP.

Clean the brake hose (1) and the 2 fittings (3,6).

CAUTION: Refer to Brake Fluid Irritant Caution in Cautions and Notices.

NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Cautions and Notices.

Loosen the 2 fittings.
Remove the 2 brake hose retainers (4,5).
Remove the brake hose from the brake pipes (2,7).
Install caps or plugs to the brake pipe fittings in order to prevent brake fluid loss and contamination.