Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the caps or plugs from the brake pipes (2,7).
- Install the brake hose (1) and the 2 retainers (4,5) to the brake pipes (2,7).
Tighten: Tighten the fittings to 15.2 N.m (11.21 lb ft).
- Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding .
- Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
CAUTION:
Refer to Brake Fluid Caution
in Cautions and Notices.
NOTE:
Refer to Filling the Master Cylinder Notice
in Cautions and Notices.