LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1363 (Hydraulic Brake System) >> Repair Instructions >> Brake Hose Replacement - Rear (Disc Brakes) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
    3. Fig 1: Brake Hose Components (Rear Disc Brakes)
    GM881830Courtesy of GENERAL MOTORS CORP.
  3. Clean the brake hose (1) and the 2 fittings (3,5).
    4. CAUTION: Refer to Brake Fluid Irritant Caution in Cautions and Notices.
    NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Cautions and Notices.
  4. Loosen the fitting (3).
  5. Remove the brake hose retainer (4).
  6. Remove the brake hose from the brake pipe (2).
  7. Install a cap or a plug to the brake pipe fitting in order to prevent brake fluid loss and contamination.
  8. Remove the fitting (5) from the caliper.
  9. Remove the brake hose from the caliper.
  10. Remove and discard the brake hose gasket.
  11. Install a cap or a plug to the caliper in order to prevent brake fluid loss and contamination.
scientia non olet · About LEMON Manuals