LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1362 (Parking Brake System) >> Repair Instructions >> Park Brake Lever Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Parking Brake Components
    GM853219Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake switch (5) to the park brake lever.
  2. Install the screw (12) to the park brake switch.
  3. Install the park brake front cable (9) to the lever.
  4. Fasten the tab.
  5. Install the lower nut (3).
  6. Install the upper nut (2).
  7. Install the park brake lever to the floor of the vehicle.
    8. NOTE: Refer to Fastener Notice in Cautions and Notices.
  8. Install the 2 bolts (4,11).

    Tighten:  Tighten the bolts to 12.5 N.m (110.6 lb in).

  9. Connect the park brake switch electrical connector (10).
  10. Adjust the park brake lever. Refer to Park Brake Adjustment (Drum Brakes)  or Park Brake Adjustment (Disc Brakes) .
  11. Install the rear floor console. Refer to Console Replacement - Rear Floor in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals