LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1362 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear floor console. Refer to Console Replacement - Rear Floor in Instrument Panel, Gages, and Console.
    2. Fig 1: Exploded View Of Parking Brake Components
    GM853219Courtesy of GENERAL MOTORS CORP.
  2. Remove the park brake lever (1). Refer to Park Brake Lever Assembly Replacement .
  3. If the vehicle has front-wheel drive, complete the following steps:
    1. Remove the catalytic converter. Refer to Catalytic Converter Replacement (LV6 Engine) or Catalytic Converter Replacement (LNK Engine) in Engine Exhaust.
    2. Remove the 3 nuts and the front floor forward heat shield.
    3. Remove the 2 nuts and the front floor center heat shield.
  4. Remove the front park brake cable (9) from the equalizer (8).
scientia non olet · About LEMON Manuals