LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1362 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Parking Brake Components
    GM853219Courtesy of GENERAL MOTORS CORP.
  1. Install the front park brake cable (9) to the equalizer (8).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. If the vehicle has front-wheel drive, complete the following steps:
    1. Install the 2 nuts and the front floor center heat shield.
    2. Install the 3 nuts and the front floor forward heat shield.

      Tighten:  Tighten the nuts to 5.5 N.m (48.68 lb in).

    3. Install the catalytic converter. Refer to Catalytic Converter Replacement (LV6 Engine) or Catalytic Converter Replacement (LNK Engine) in Engine Exhaust.
  3. Install the park brake lever (1). Refer to Park Brake Lever Assembly Replacement .
  4. Install the rear floor console. Refer to Console Replacement - Rear Floor in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals