LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1362 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Equalizer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Parking Brake Components
    GM853219Courtesy of GENERAL MOTORS CORP.
  1. Install the 3 park brake cables (6,7,9) to the equalizer (8).
  2. If the vehicle has front-wheel drive, complete the following steps:
    1. Install the front floor center heat shield and the 2 nuts.
    2. Install the front floor forward heat shield and the 3 nuts.

      Tighten:  Tighten the nuts and the bolts to 5.5 N.m (48.68 lb in).

    3. Install the catalytic converter. Refer to Catalytic Converter Replacement (LV6 Engine) or Catalytic Converter Replacement (LNK Engine) in Engine Exhaust.
  3. Inspect the park brake lever travel. Adjust as necessary. Refer to Park Brake Adjustment (Drum Brakes)  or Park Brake Adjustment (Disc Brakes) .
  4. Install the rear floor console. Refer to Console Replacement - Rear Floor in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals