Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Retractor Bolts, Adjuster, Bolt, Cover, And Retractor Assembly

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rear seat belt retractor (2) to the vehicle. Secure the retractor with the upper mounting bolt (3) and the lower mounting bolt (4).
Tighten:
- Tighten the rear seat belt retractor upper mounting bolt to 51 N.m (44 lb ft).
- Tighten the lower mounting bolt to 41 N.m (30 lb ft).
Install the rear seat belt retractor lower anchor bolt (5).
Tighten: Tighten the rear seat belt retractor lower anchor bolt to 41 N.m (30 lb ft).
Install the left shoulder adjuster (7) with the bolt (8).
Tighten: Tighten the left shoulder adjuster bolt to 42 N.m (31 lb ft).
Install the left shoulder adjuster bolt cover (1).
Install the left lower quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter Lower .
Install the child tether upper anchor brackets. Refer to Child Restraint Tether Anchor Replacement (Upper) .
Install the tool storage compartment tray.
Install the tool storage access panel. Refer to Accessory Panel Replacement - Rear .
Install the rear compartment access panel. Refer to Accessory Panel Replacement - Rear .
Install the rear storage compartment. Refer to Storage Compartment Replacement - Rear .
Install the left seat garnish trim.
Install the left rear door sill trim. Refer to Door Sill Plate Replacement .
Install the left rear seat hinge. Refer to Seat Back Hinge Replacement - Rear Outer .
Install the left rear seat. Refer to Seat Replacement - Rear .